Navigation:  INTRODUCTION > Install Jewelry Shopkeeper >

4. Reboot

Previous pageReturn to chapter overviewNext page

 

When the installation process is complete, a message will appear to tell you that the process was successful. Press <Enter> to continue.

 

Remove the installation diskette from the floppy drive, and put your Jewelry Shopkeeper diskette(s) in a safe place. You will not need these diskettes to use the system on a day-to-day basis. Next, you must reboot (restart) your computer.

 

Reboot the computer by pressing the <CTRL>, <ALT>, and <DEL> keys at the same time. The screen will go blank, and the computer will take a few moments to start up.